Landing gear Failure could be caused by too much over center.
Date: 06/12/2011
Views: 2284
Newest Image
EAA SITE
Date: 08/23/2023
Views: 158990
sil3
Finished plating both sides of the thin single strand copper wire on port side of aeroplane. There is only perhaps 1/4" between outboard side of wire and terminal blocks (they have tape on them), no problem plating in situation! Just used a piece of Scotchbright to clean up and a mixing stick with a rag taped on it. The terminal block on the left side was sanded down and was bare brass. Hand screwed in two 6-32 1" screws and silver plated with a toothbrush.
Y9-01-06