Orange part created in turbocad and printed on a 3D printer from ABS. Printer is a Prusa i3 X, cost is around $300.
Date: 04/03/2016
Views: 17154
Ceiling panel layout begins
Date: 03/05/2009
Views: 3046
IMG_0059
Date: 05/03/2007
Views: 3293
Newest Image
EAA SITE
Date: 08/23/2023
Views: 87446
IMG_5308
Fitting the side piece, the first problem becomes visible. It is attached to the frame using two P clips. The upper one is fine, but the lower one sticks out from underneath the lower flange. This flange is narrower than the upper, which IS according to template. TIP- make the flange wider, if only locally.