|
IMG_1537ann
Did move on to the cover for the old gear well. Getting a decent but not perfect fit. Will continue to work on it.
Date: 06/19/2011
Views: 2982
|
|
1_Door_Knobs
I didn't like the previous door handle hardware. Threaded end with nut stuck out and caught on the door handle guard plate when the handle was pushed closed. Purchased new stainless steel binding posts from McMaster-Carr. Worked great. More detail und
Date: 06/23/2011
Views: 2897
|
|
2_Door_Knobs
Nice low profile head
Date: 06/23/2011
Views: 3236
|
|
3_Door_Knobs
And low profile screw end that won't catch on the door handle guard plate.
Date: 06/23/2011
Views: 2881
|
|
1_snaps
The headrest snap bases for the seat back tabs were never done well by my upholstery guy. Just a skinny screw through the hole where a big rivet had been removed. And simple nuts on the underside.
Date: 06/23/2011
Views: 2989
|
|
2_snaps
The snap bases pulled off the screws first time the seat back was removed.
Date: 06/23/2011
Views: 2936
|
|
3_snaps
Went to good old McMaster-Carr and, sure enough, they had multiple options for screw-down snap bases. Ordered these nice stainless steel snap bases with integral 6-32 screw. Used AN970 washers and nylock nuts to hold them on. Nyloc because when I remov
Date: 06/23/2011
Views: 2857
|
|
4_snaps
Old snap base installation with the new snap base.
Date: 06/23/2011
Views: 2898
|
|
5_snaps
New snap bases bolted down and ready to go.
Date: 06/23/2011
Views: 2687
|
|
6_snaps
Seats reinstalled in the cockpit. Snap tabs to the headrests work great now. A bit more detail is available in the Modifications album
Date: 06/23/2011
Views: 2883
|