1/2" ball end-mill on order (McMaster) to to mill a pocket in the brake master cylinder directly above the mounting holes
Date: 12/13/2013
Views: 4475
IMG_0148Ann
Date: 12/24/2008
Views: 4134
Newest Image
EAA SITE
Date: 08/23/2023
Views: 209805
IMG_6450post
The carb pressure connections. It does run rough without that balance tube connected. Spent about 2 hrs & 15 minutes (0730 - 0945) getting the idle speed set and balanced. Then balancing again at 3600 RPM. When all balanced at max sensitivity, shut down and reconnected the balance tube. Ran the engine to check it out from idle to 5800 rpm. Smooth as a well oiled sewing machine.