1/2" ball end-mill on order (McMaster) to to mill a pocket in the brake master cylinder directly above the mounting holes
Date: 12/13/2013
Views: 3772
IMG_0148Ann
Date: 12/24/2008
Views: 3445
Wing_Dolly_08
Date: 01/28/2006
Views: 3174
Newest Image
EAA SITE
Date: 08/23/2023
Views: 87123
RudderMount09Ann
With the tip in place, I could figure out where the rudder will be positioned, vertically. From there, I could determine where the hole for the rudder actuator rod needed to be located in the sternpost. I was then able to drill the hole.