Orange part created in turbocad and printed on a 3D printer from ABS. Printer is a Prusa i3 X, cost is around $300.
Date: 04/03/2016
Views: 18343
Ceiling panel layout begins
Date: 03/05/2009
Views: 3389
Newest Image
EAA SITE
Date: 08/23/2023
Views: 159845
ThrottlePlate00
The center- line of the plate was measured and marked. The measurements for the throttle lever slot and screw holes were taken from the throttle quadrant and transferred to the back of the plate. A jig was set up to position the drill on the center -line of the plate.