TrimSwitchesAnn
Since I am moving the trim switches to the control sticks (Turned out to be a bad decision). Went back to the old setup in the end), I no longer need the holes I made for the trim switches and indicator in the console between the seats. I cut three small rectangular pieces of plwyood and fitted them into the holes. Mixed a tiny batch of epoxy and epoxy/FLOX. applied the epoxy to the holes and wood and pressed the wood into the holes. Applied FLOX to fill in the small gaps. Applied the remaining epoxy over the surface and laid up a single ply of BID over the console. Covered the layup with peel ply. No pic, but also put a piece of plywood on top and laid a 25# bag of shot on top of that to press it all down and make a good solid layup.
|
Full size:
640x480
|