Going to taper sand away about half thickness of aluminium at tip 2.
Date: 10/22/2009
Views: 3245
45_CS_hardware
Date: 12/31/1969
Views: 2041
Newest Image
EAA SITE
Date: 08/23/2023
Views: 120336
dsc09022
Here you see I used bondo on the shims and screwed them down into the block. The shims made sure the guide was level. Also note the hole drilled in the Aluminum angle and the shim. This is where I fixed the guide for the curing stage to ensure nothing moved.
Here you see I used bondo on the shims and screwed them down into the block. The shims made sure the guide was level. Also note the hole drilled in the Aluminum angle and the shim. This is where I fixed the guide for the curing stage to ensure nothing moved.