|
Ipad 041
Shed Under construction
Date: 03/27/2014
Views: 7363
|
|
|
IMG_0390
Date: 04/10/2015
Views: 7341
|
|
|
IMG_0389
Rear Bulk head fixed and peel plyed
Date: 04/10/2015
Views: 7242
|
|
|
IMG_0392
Date: 04/10/2015
Views: 7215
|
|
|
Rivets
Next problem. Once the push rod end was fitted and drilled according to the manual the rivets provided were too short to go through the whole structure. Awaiting a response from Europa
Date: 09/03/2015
Views: 7214
|
|
|
DSC00157
Instructions state that rod should be reamed to 0.375" but it needed to be reamed out 0.428" to fit push rod.
Date: 09/03/2015
Views: 7201
|
|
|
DSC00228
Had to remove more of the rudder than I wanted so build up rudder trailing edge by attaching peel ply to the outside of the rudder and build up trailing edge using flox around the edge and an initial 2 ply of bid. i'll apply an additional 2 ply after the
Date: 09/10/2015
Views: 6910
|
|
|
Ipad 039
Concrete base for 20ft x 10ft shed
Date: 03/22/2014
Views: 6633
|
|
|
DSC00155
As you can see the Issue 1 Bearings are considerably longer and will require shortening once I have the correct dimensions.
Date: 09/03/2015
Views: 6575
|
|
|
IMG_0823
Same of port side.
Date: 09/03/2015
Views: 6538
|
|
|
IMG_0821
Trial fitted the torque tube but it looks like the TP38 bearing is too short!
Date: 09/03/2015
Views: 6458
|
|
|
Torque tube
Took some measurements and sent query to Europa. Response was I required the issue 1 TP38s
Date: 09/03/2015
Views: 4719
|
|