|
|
DSCF0046
Date: 10/27/2009
Views: 7546
|
|
|
3_snaps
Went to good old McMaster-Carr and, sure enough, they had multiple options for screw-down snap bases. Ordered these nice stainless steel snap bases with integral 6-32 screw. Used AN970 washers and nylock nuts to hold them on. Nyloc because when I remov
Date: 06/23/2011
Views: 4414
|
|
|
|
IM003698
Date: 12/04/2007
Views: 7746
|
|
|
CIMG2119
Date: 05/24/2007
Views: 5859
|
|
|
|
DSC_0205
Date: 05/15/2008
Views: 4925
|
|
|
Starboard wing close out repair 10.
Date: 06/15/2009
Views: 5485
|
|
|
|
DSC_0025
Date: 08/31/2007
Views: 5961
|
|
|
Archer_6_antenna_install_11
Date: 01/23/2009
Views: 6150
|
|
|
|
Rotax_oil_line_1
Date: 03/24/2009
Views: 6570
|
|
|
Oxford_EGTK
Date: 07/25/2009
Views: 4513
|
|
|
|
DSCF0034
Date: 08/03/2009
Views: 6093
|
|
|
SScableends
Date: 12/01/2006
Views: 5103
|
|
|
|
Top bond on 4.
Date: 04/30/2009
Views: 5092
|
|
|
IMG_7773Ann
Date: 06/14/2008
Views: 3898
|
|
|
|
DSCN6177
Date: 10/11/2009
Views: 5877
|
|
|
IMG_6794post
Starting point for the measurement of the main square beam. Also shows where the tailwheel "U" channel begins.
Date: 12/10/2009
Views: 8383
|
|
|
|
photo (1)
Bad pic, but shows the end of the reinforcement layups (port side).
Date: 08/20/2012
Views: 40071
|
|
|
IMG_2685
I elected to make up a support structure from some 12" 1 1/2 x 1 1/2 wide aluminum angle i had in my aluminum bin. Cut two lengths 5 1/2" long and clamped them to the base well centered and drilled out holes matching the base. Attached them t
Date: 04/09/2012
Views: 4765
|
|
|
|
Mod 44
Date: 08/26/2010
Views: 4814
|
|
|
IMGA0023
Date: 09/18/2014
Views: 52005
|
|
